Operation procedure of aluminum powder ball mill

1. Check all parts of machinery and electrical equipment before driving, check whether the connecting bolts are loose; whether the lubrication points are normal, whether the transmission device is normal and reliable, the protection device is intact, the electrical instrument is sensitive, and the motor carbon brush is in good contact.

2. Drive the car for one week, check the rotating parts of the equipment or around it for obstacles and eliminate it. No one is allowed to stand around when starting.

3. After checking the error, press the start button to start the motor and pay attention to the current change. The aluminum powder grinding machine shall not start more than twice in a row, and the first time and the second time shall be separated by more than 5 minutes. If it is started for the third time, it must be checked with the electrician and the fitter before starting. Do not start with other equipment, and stagger start to avoid tripping.

4. After the aluminum powder grinding machine is in normal operation, it is necessary to strictly follow the provisions of water supply, ore supply and steel ball addition. It is forbidden to overload operation, and the idle time is not more than 15 minutes, so as to avoid damage to the liner.

5, in the operation should pay attention to check whether the cylinder leaks, carefully observe the current, voltage, feeding, water supply is normal, every half an hour to check the motor and spindle temperature is not greater than 60 ° С, found problems in a timely manner.

6. During operation, pay attention to observe whether the hollow shaft and the oil ring rotate with oil, and whether the temperature of the hollow shaft is normal. If the hollow shaft is found to be hot, close to the burning tile, the forced cooling measures should be taken immediately, and the parking should not be stopped immediately, so as not to cause the axle to be hung. ". At the same time, pay attention to check the oil quantity and temperature of each lubrication part, and regularly add fuel.

7. The aluminum powder ball mill should stop feeding before stopping, and stop the water supply after the concentrate is processed. Press the parking button and pull down the switch.